T3 Dash Cams can be woken remotely for 30 minutes, for up to 72 hours after the vehicle’s ignition is turned off. This allows you to access recorded footage without returning to the vehicle or turning its ignition back on.
Remote wake-up is helpful when a vehicle is parked at another location, in service, or unable to be powered on after an incident.
Note: This feature is available to T3 Dash Cams customers. A cellular connection is required to wake the camera remotely.
Wake the Camera and Play Video
In T3 Driver Safety, open the asset’s video viewer.
Select Video History.
Use the date selector and timeline to locate the footage you want to review.
Check the camera status below the camera views. If the camera is asleep, select Wake & Play Stream.
Allow a few minutes for the camera to wake and connect before playback begins.
Understand Camera Statuses
The camera status helps you determine whether footage can be retrieved or the vehicle needs to be powered on.
Status | What it means |
Camera asleep | The vehicle’s ignition is off. Select Wake & Play Stream to wake the camera before playback. This may take a few minutes. |
Camera offline | The camera cannot be woken remotely. Contact the driver to power on the vehicle before trying to retrieve footage again. |
Camera online | The camera is on and ready to request video. |
Request Video Footage
For instructions on requesting footage, see Requesting Dash Cam Video Footage in T3 Driver Safety.
If the Camera Does Not Wake
Check the time since the ignition was turned off. After 72 hours, the vehicle must be powered on before the camera can reconnect.
Consider cellular coverage. Poor cellular service may prevent remote wake-up.
Check the camera status. If Camera offline appears, contact the driver to power on the vehicle.

