This article walks through calibrating a T3 Dash Cam installation with the Titan FTS App to minimize false alerts and ensure accurate driver behavior tracking.
Download the Titan FTS App
On-Site Camera Calibration
Log in to the Titan FTS App with the provided login credentials.
Username: install
Password: camera22
Locate the Camera.
Tap Search Nearest Camera.
If the camera is not found, tap Insert SSID and manually enter the SSID located on the side of the camera (e.g.,
ST-xxxxxxxxxx).
Follow the on-screen instructions.
⚠️ Do not wire into the vehicle's blinkers.
Calibrating AI Road Camera
Set Camera Height
Measure from the ground (where the tire meets the road) to the camera lens.
The default height is 153 cm.
Mounting Position
Select Centered or Not Centered based on installation.
For vehicles/equipment with split windshields, choose Not Centered.
Additional Measurements (if not centered)
Enter:
Camera Distance from Left Edge (distance from the lens to the asset's leftmost front edge).
Front Width of the Vehicle (overall width at the front).
Save Settings
Tap Apply Changes.
Calibrating AI Driver Camera
Select Camera 2
This refers to the AI Driver Camera.
Set Steering Position
Choose Left-Hand Drive or Right-Hand Driver
Adjust Driver Camera Lens
Open the bottom panel of the camera.
Use the adjustments tab to position the driver's face just above the centerline in the live stream view.
Confirm Settings
Tap Confirm to save.